Kenwood B60-0763-00 - Manual (Page 15)

!
To mute the sound temporarily
REMOTE CONTROL ONLY
I
Note on LOUDNESS control (For Europe only)
Listening at high volume allows to enjoy dynamic sound, but
human ears tend to feel low frequencies insufficient when
listening at low volume. When the VOLUME CONTROL is set
to a low position, the insufficiency of low frequencies felt by
human ears can be compensated by turning the LOUDNESS
control clockwise.
Enhances low frequencies.
• The effect of LOUDNESS control is less sensible if the
VOLUME CONTROL is set to the ’5’ position or above.
Listening through headphones
1 Insert the headphone plug into the
headphones jack.
e Set the SPEAKERS switch so that both speaker systems A
and B are OFF.
2 Adjust the volume.
VOLUME CONTROL
,2l3yT6l6j7,g
e Be sure to minimize the volume before unplugging the head­
phone plug.
Notes:
1. When the TAPE 2 key is set to ON, the source selected with
the INPUT SELECTOR cannot be heard from the speakers.
To listen to a source other than cassette deck 2, be sure to
set the TAPE 2 key to OFF.
2. The source selected with the INPUT SELECTOR is backed
up for a few days even when the power cord is unplugged.
After this period, the tuner is automatically selected when
the power is supplied.
STAND BY mode of POWER switch
When the power cord of this system is plugged into an AC
outlet, the STAND BY indicator lights up regardless of the
ON/OFF setting of the POWER switch. This indicates that a
small amount of current is being supplied to the unit to back up
the memory contents. This mode is referred to as the Stand By
mode. While the STAND BY indicator is lit, the power of the
system can be switched ON/OFF from the remote control unit.
KR-V6040 (En)
15