Canon 400 - Manual (Page 11)

7
Work safely!
Unpacking: What's in the box?
When you unpack the box, use the checklist below to make sure
that you have everything. If anything is missing, contact your sup-
plier.
■ Microfilm Scanner 400
■ Halogen lamp
■ Power cord
■ Lens label
■ Instructions
■ Warranty Card (U.S.A. and Canada only)
Important parts and their functions
Before you use the unit, take a few minutes to become familiar
with the names of the important parts.
Screen
Displays images and allows you to view
images before you print them.
Area setting cursor (option)
Allows you to define and trim
an area for printing if you do
not want to print the entire im-
age.
DIN connector
Allows you to connect a
cable for the Autocarrier
100C, 100R, 100M, FS
Controller I or Roll/Fiche
carrier 200.
Light adjustment dial
Allows you to adjust the intensity of the light.
Adjust to the magnification power of the inter-
changeable lens.
Operation panel
Provides keys that allow you to perform
settings for image adjustment or film
mode selection.
Power switch
Allows you to turn power on and
off.
Carrier stage
Holds an interchangeable
carrier.
Lamp unit
Holds the lamp for the main source of
illumination. Remove to change the
halogen lamp.
Film control knob (option)
Allows you to transport film on the carrier you
have installed. Turn the knob right to advance
the film and turn it left to reverse wind the film.
(This is not possible with the FS Controller I or
III.)
Lens holder
Holds an interchangeable
lens