Toshiba TEC MA-305-100 - Manual (Page 15)

EOl-11068
Numeric Display
AMOUNT (8 digits for total display, 7 digits for entries):
Displays the numeric data, such as amount, quantity, etc.
When the obtained total or subtotal amount is 8-digit, the
RPT digit is also used for the amount display. When no
entries are under way and the Control Lock is in the REG
position, the current time is displayed.
DP (2 digits): Displays the code which represents each Department key.
It stays lit when repeating the same department entry.
RPT (1 digit): Displays the repeat count of the same item. The count is
indicated from the second entry on, and only the last digit
will be displayed even if the count exceeds nine.
PLU“{3 dfgits of th^DP and RPT are used for this^u rpbse):
Displays the PLU code when any PLU is entered. It goes
out when repeating the same PLU entry, then only the
RPT digit will be displayed for the repeat entry count.
Message Descriptors (Triangular Lamps)
Illuminates when a cashier has signed ON.
SIGN .
ON *
ALM
R
OFF
TL :
ST ;
CG :
Illuminates with the alarm buzzer to indicate that the last
operation or numeric entry was an error. To clear the error
condition, depress the [C] key.
Illuminates when the Receipt-OFF mode is declared by the
[LOG/RECEIPTJ key. In this condition, no receipts will be
issued for a sale to be entered. To extinguish this lamp (i.e., to
change into Receipt-ON mode for issuing receipts), simply
depress the [LOG/RECEIPT] key again.
illuminates with the total amount displayed when a sale is
finalized without any amount tendered.
Illuminates with the subtotal amount displayed when the [ST] or
[TXBL TL] key is depressed.
When an amount tendering operation has been performed, this
lamp illuminates with the amount of change due displayed.
- 1 3 -