Toshiba TEC MA-305-100 - Manual (Page 57)

EOl'11068
NOTES 1. When a rate is manually entered through a % key preset with a rate, the manual
rate prevails.
2. A % entry will cause an error if operated after an Other Income Department or
Negative Department entry.
3. A % entry after obtaining a Subtotal is usually allowed only once. However, it can
be programmed to allow multiple times. (Refer to Chapter "79. System Option
Setting*’, Address 16
■ Bit 2.
4. You can select the rounding process of the fractions of the product (result of
multiplication) - ROUND OFF (initial setting), ROUND UP, or ROUND DOWN.
(Refer to Chapter “19. System Option Setting“ Address 2 - Bits 1 and 2.)
Example of % Discount on Item Example of % Charge on Sale Total
0 1 * 6. 0 0 TM
5. % -
- 0.3 0
■ Dept. 1 $6.00
I]
1— 5% on $6.00
= $0.30
is discounted
★ 1 5. 0 0 ST ^
10 % +
* 1.5 0
Dollar Discount DOLL
DISC
(Dollar Discount Key)
Dollar Discount is used to subtract an amount from the sale total.
X
Use the REG Key to turn the
Control Lock to “REG”.
REG
OFF
SET
Sale Item Entries
■Ln.......
□
Amount to be
discounted
(max. 7 digits)
.Subtotal $15.00
’ obtained.
10% on $15.00
* $1.50
is added
TX/M
at
DOLL
DISC
__ Depress
either of two positions
for reversing the tax
status of the [DOLL
DISCI key.
CAUTION; See previous page.
NOTE For entering a Dollar Discount that will cause the sale total into negative (credit
balance), refer to Chapter “19. System Option Setting” Address 2 - Bit 3:
If status “Credit Balance Prohibited” (initial status) is selected:
Over^subtraction of the safe total by Dollar Discount causes an error.
If status “Credit Balance Allowed" is selected:
Over-subtraction of the sale total by Dollar Discount is possible.
Example of Dollar Discount Entry
“04 0
.An amount of $0.40 is
entered as Dollar Discount
- 55 -