Using the surround function, Jii ^ ^5i„y7, Surround modes and parameters – Denon AVR-2500 User Manual
Page 17: Using the personal memory function, Presetting, Recalling
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Using the surround function
1. Select the surround mode according to
the input source.
SUPE«
STADIUM
MODE
.Jii....... ^
^5i„y7
2, if necessary, adjust the levels.
h
Q
r
3. Adjust the parameters to the desired
settings.
4. To check the DSP effect, press the EFFECT
button to turn the effect on and off.
CZD
PSP £FfiC:
5. To set the parameters back to the stan
dard settings, press the CLEAR button.
CLEAR
Surround modes and parameters
DELAY TIME ........................... This can be set to between 15 and 30 msec for the DOLBY PRO LOGIC mode, between 0 and 360 msec for
the MATRIX mode. It is controlled directly with the DSP EFFECT " + " and " - " buttons.
These parameters can be used in modes other than the DOLBY PRO LOGIC and MATRIX modes.
ROOM SIZE............................. "Room size" refers to the size of the sound field,
EFFECT LEVEL....................... "Effect level" refers to the strength of the effect sounds. If the sound is distorted or seems strange, lower
the level.
EFFECT................. .................. This can be used in surround modes other than DOLBY PRO LOGIC, WIDE SCREEN, LIVE SURROUND and
MATRIX MODE,
CENTER LEVEL....................... This can be used in the DOLBY PRO LOGIC, WIDE SCREEN, and LIVE SURROUND modes when the center
mode is set to the norma! or wide mode. In other cases, the center output is automatically turned off.
CENTER MODE....................... When this is selected in the DOLBY PRO LOGIC mode, the wide screen and live mode center modes are
automatically set.
* Using the Personal Memory function
The personal memory function allows you to store the current
input position and surround mode in memory. Both settings
can then be recalled instantly by pressing a single button.
Presetting
1.
Set the desired input position and sur
round mode using the procedures de
scribed in sections 4-2 and 4-8.
2. Press the Personal memory "MEMORY"
button. The standby mode is set.
3. Press the button (1 to 3} at which you
want to store the setting.
The setting is now stored,
iii The OAT/TAPE MONITOR position can
not be stored in the memory.
Recalling
4. Press the button {1, 2 or 3} at which the
desired setting has been stored.
The unit automatically switches to that
setting,
—•PERSONAL MEMORY —
1
2
.3
______ I
□
i|
I I a 3
/ 7
PgRSCNAl /
IX
I ^
17