Denon AVR-2500 - Manual (Page 8)

Ш NORTH AMERICA MODEL ONLY
* AC OUTLETS
SWITCHED lEOWtIAIMAX.
AC OUTlfTS t20V-e0Ki
NOTE:
Only use the AC outlets for audio equipnnent. Never use
them for hair driers, TVs or other electrical appliances.
Connecting the AC OUTLETS
AC OUTLETS -
• SWITCHED (total capacity - 120W (1A)1
The power to this outlet is turned on and off in conjunction with
the POWER switch on the AVR-2500, and when the power is
switched between on and standby from the remote control unit.
No power is supplied from these outlets when the AVR'2500's
power is at standby. Never connect equipment whose total
capacity is above 120W (1A).
H MULTI-VOLTAGE MODEL ONLY
Make the following settings before connecting the comporfents.
1. Setting the frequency step
FREQUENCY
STEP
50kHz 200kHz FM
9kHz 10kHz AM
2. Setting the line voltage
LINE VOLTAGE ■
Set the FREQUENCY STEP switch as described below,
• In the U.S.A. and Canada - set the switch to 200 kHz / 10 kHz side.
With this setting, the frequency varies in 200 kHz steps in the range of
87.5 to 107.9 MHz (FM) and in 10 kHz steps in 520 to 1710 kHz {AM},
• Elsewhere - set the switch to 50 kHz / 9 kHz side.
With this setting, the frequency varies in 50 kHz steps in the range of
87.50 to 108.0 MHz (FM} and in 9 kHz steps in 522 to 1611 kHz (AM).
Only switch the frequency when the power cord is unplugged.
Plug in the power cord securely after switching the frequency.
The customer can set the VOLTAGE SELECTORS on the back panel for
appropriate line voltage by using a screwdriver.
Do not use excessive force in setting the VOLTAGE SELECTOR KNOB -
you may damage it.
If the VOLTAGE SELECTOR KNOB does not turn smoothly, contact your
store of purchase.
8e sure to set both voltage selectors to same position.
3. AC OUTLET
NOTE:
Only use the AC outlet for audio equipment. Never use
them for hair driers, TVs or other electrical appliances.
8