Denon AVR-2500 - Manual (Page 22)

6 EASY OPERATiOIM FUNCTIONS
This unit is equipped with the functions described below to make operation simpler.
6-1 On-screen display
Each time an operation is performed, a description of that operation appears on the
display connected to the unit's VIDEO MONITOR OUT terminal. Also, the unit's
operating status can be checked during playback by pressing the remote controhwnft's
ON SCREEN button.
Such information as the position of the input selector and the surround parameter
settings is output tn sequence.
The output from the S MONITOR OUT terminal has priority for the on-screen display. If
you want to always output the on-screen display signals to the video output, do not
connect a cable to the S MONITOR OUT terminal.
The on-screen display is not displayed for the MULTI SOURCE MONITOR OUT
terminal. '
This model's on-screen function is designed for high resolution monitor displays.
Small characters may be difficult to read on small displays or !ow resolution TVs.
6-2 Front pane! display ^
Descriptions of the unit's operations are also displayed on the front panel display/, in
addition, the display can be switched to check the unit's operating status while playing
a source by pressing the remote control unit's PANEL button,
‘ON SCREEN'
6-3 Personal memory
This is a function allowing you to easily set the input position and surround mode with
a single button once the input selector and surround mode have been preset.
For details, refer to Page 17.
6-4 System call (Remote control unit)
This function allows you to preset frequently used operation patterns in the remote control unit then
automatically send a series of up to ten remote control codes with a single button.
Presetting
1, Press the SET button.
( 1 ) ГТ1
SYSTEM CALL
Press the buttons for the codes to be sent,
changing the position of the slide switch as
necessary, (Up to ten buttons can be set.}
Buttons which have been "learned" and buttons
which have been preset can also be selected.
CD CD
SYSTEM CALL
'Q;
IT!
INITIALIZATION OF THE MICROPROCESSOR
When the indication of the MFD display is not normal or when the
operation of the unit does not shows the reasonable result, the
initialization of the microprocessor is required by the following
procedure.
1. Switch off the unit and remove the AC power cord from the
wall outlet.
2. Hold the following AUDIO FUNCTION button and VIDEO
FUNCTION button, and plug the power cord into the outlet.
3. Check that the entire display is flashing with an interval of
about 1 second, and release your fingers from the 2 buttons.
4. Switch on the unit and the microprocessor will be initialized.
3, Press the SYSTEM CALL button ("1" or "2") at
which you want to store the codes.
The setting is now stored.
Recalling
4, Press the SYSTEM CALL button ("1" or "2") at
which the desired codes have been stored.
The series of codes is now sent.
22