Toshiba MA-290-100 SERIES - Manual (Page 78)

PAPER ROLL REPLACEMENT AND OTHER MAINTENANCE OPERATIONS
Journal
Winding
Reel
Fig. 1
Fig. 2
Fig. 4
INSTALLING THE RECEIPT PAPER
1 . Turn the Mode Lock to the "REG"
position with the power on.
2. Remove the Paper Cover by pulling it
upward, and remove the Journal
Winding Reel (Fig. l).
3. Hold a new paper roll in the
direction as shown in Fig. 2 so that
the paper end will be fed from the
bottom.
4. Fold the paper end firmly as shown in
Fig. 3 to ease the insertion.
5. Place the paper roll in the
outer-side holder of the two roll
holders (Fig. 4).
6. Insert the paper end into the Receipt
Inlet, feed the paper in while
pressing down the Free Lever (or feed
the paper in while pressing the [RF]
key). (Fig. 5)
7. When all the folded portion comes
out, tear off the unnecessary part
with an approprate end length
remaining (approx. 5cm or 2 inches).
(Fig. 6)
8. Go on to INSTALLING THE JOURNAL PAPER
steps if necessary, or go on to Step
8 below if not.
9. Attach the Paper Cover. Meanwhile,
the paper end must be seen outside
the cover.
0. Press the [C] key to clear the
paper-end condition, and depress the
[NS] key and cut the issued receipt
to check if the paper has properly
been set.
Receipt
Inlet
Free Lever
Fig. 5
Fig. 6
Approx. 5cm
REMOVING THE RECEIPT PAPER
1. Remove the Paper Cover by pulling it
upward (Fig. 1).
2. Press the Free Lever down and pull
the old paper core puward to remove
the remaining paper end (Fig. 7).
Fig. 7