Toshiba MA-290-100 SERIES - Manual (Page 8)

DISPLAY
The Operator's Display (front display) is located at the top of the register
just above the keyboard. The Customer's Display may be used as Rear Display,
or used as Remote Display if it is popped up and turned to the required
direction. The display has two types of display -- numeric display and
message descriptors.
FRONT DISPLAY
PLU
' OPT RPT A M O U N T
0 1 /
/
i ? 3 4 5 6
n
1
8
f f f f f f f T T f f
SHORT
SLP ALM REG (-) FS TXBL ST TL cs
TRF
REAR/REMOTE DISPLAY
Numeric Display
AMOUNT (8 digits) Displays the numeric data, such as amount, quantity, etc.
DPT (2 digits)
RPT (1 digit)
Displays the code which represents each Department Key.
It stays lit when repeating the same department entry.
Displays the repeat count of the same department or PLU
item. The count is indicated from the second entry on,
and only the first digit will be displayed even if the
count exceeds nine.
PLU (4 digits, shares common digits with DPT, RPT digits, and the leftmost
AMOUNT digit.)
Displays the PLU code when ay PLU is entered. It goes
out when repeating the same PLU entry.
Message Descriptors (Trisiark Lasq>s)
Leftmost Trimark Lamp
Lights up when an item is entered through the scale connected to
the register.
It also lights up or flickers if the register is connected to an
in-line cable (Register-to-Register System), which will be
described in detail in a separate manual.
SLP Lights up when a slip has properly been inserted and set to allow
validation print.
It flickers to require a slip insertion when validation
compulsion has been programmed on the transaction key just
operated.
- 4 -