Toshiba TEC MA-1040-400 Series - Manual (Page 54)

JOURNAL AND RECEIPT PAPER-END DETECTOR
(1) This detects when either the journal or receipt paper is coming near
the end. It is provided in order to prompt the operator to replace
the old paper roll with a new one.
(2) When the paper roll comes near the end (or the paper has not been set
properly), no key operation (except [RF] and [JF]) will be accepted
and the AMOUNT portion of the display will keep flickering,
(3) When a new paper roll is set, only the [RF] and [JF] keys are allowed
to operate. Next, when the [C] key is depressed, the display
flickering will be cleared and normal key-in operations will be
accepted. If any printing was suspended, it will continue printing,
(4) If this detector sensed a paper-end condition during printing, the
printer will stop after the current line printing is completed.
(5) The [RF] and [JF] keys are operative regardless of the detector on/off
condition.
(6) If the [C] key is depressed in the paper-end condition, it will be
ignored. The [C] key depression will be effective to clear the
display flickering only after the new paper roll is set.
PRINTER MOTOR LOCK DETECTOR
(1) This detects the printer motor lock condition caused by some trouble.
(2) When such a condition is detected, the front display indicates
"Error", and none of the keys (including [RF] and [JF]) will be
accepted.
(3) To regain the normal condition, turn the power of the ECR to OFF,
remove the cause of the motor lock, and then turn the power to ON
again.
- 50 -