Toshiba TEC MA-1040-400 Series - Manual (Page 7)

CLERK LOCKS AND KEYS
Key-lock Type (Standard)
1 «2 3*4
These locks are used to identify which
clerk is operating the register.
Clerk Keys (1^ 2, 3, 4)
Each clerk should keep his/her clerk key. The
register will not operate unless one of these
keys is inserted and set to the corresponding
position on the Clerk Locks, Each of the keys
may be inserted and pulled out in the neutral
position marked with the (point).
Push-key Type (Alternative Option)
1 2 3 4 _
This type may be installed in place of the standard
key-lock type mentioned above, as an alternative
option. Each clerk is assigned to his/her own
clerk key (1 to 4). The register will not operate
unless one of these keys is pushed to stay down.
DISPLAY
The Operator's Display (front display) is located at the top of the register
just above the keyboard. The Customer's Display may be used as Rear Display
if it is kept in the receptacle or used as Remote Display if it is stretched
up and--turned to the required direction. The display has two types of display
-- numeric display and message descriptors.
The angle of the Operator's Display in the up-and-down direction is adjustable.
OPERATOR*S DISPLAY
P L U
DPT RPT A M O U N T
n
/
D / “/ D U
C r n
n
u 1 L / L -J
1 „1 U / u
V V V V V V V V V V V
SLP ALM REG (-) FS TXBL ST TL CG SHORT
CUSTOMER'S DISPLAY
- 3 -