Toshiba IK-DP20A - Manual (Page 20)

3. Position the cursor next to SCAN SPEED and press the OPEN button to move the
cursor to the right.
4. Move the joystick up or down to set the speed.
5. To accept the selection, press the OPEN button or to cancel the selection, press
the CLOSE button.
6.5.8 SCAN TILT ANGLE
The tilt angle of the dome camera for auto scan, random scan and frame scan can be
set from 0 to 85 degrees or 92 degrees (0 degree is straight down).
To set SCAN TILT ANGLE:
1. Enter 95 preset to access the main menu.
2. Position the cursor (->) next to PAN/TILT SETUP and press the OPEN button to
access the PanTTilt menu.
3. Position the cursor next to SCAN TILT ANGLE and press the OPEN button to move
the cursor to the right.
4. Move the joystick up or down to set the tilt angle.
5. To accept the selection, press the OPEN button or to cancel the selection, press the
CLOSE button.
6.5.9 STOP TIME
During frame scan, random scan or auto patrol, a stop time from 10 sec to 60 sec can
be set. During scanning, the camera will not move for the specified time at each stop.
To set STOP TIME:
1. Enter 95 preset to access the main menu.
2. Position the cursor (->) next to PAN/TILT SETUP and press the OPEN button to
access the Pan/Tilt menu.
3. Position the cursor next to STOP TIME and press the OPEN button to move the
cursor to the right.
4. Move the joystick up or down to set the stop time.
5. To accept the selection, press the OPEN button or to cancel the selection, press
the CLOSE button.
B.5.10MAX SPEED
The maximum speed of Pan/Tilt functions can be set from 30 degrees/sec to 300
degrees/sec. The max speed controls global Pan/Tilt speeds. To reduce rotation
loise, a lower speed is recommended.
-
19
-