KORG Concert 800 - Manual (Page 19)

U s i n g t h e P r o g r a m C h a n g e F u n c t i o n
The Following Timbre Numbers Are Accepted by the C-800 to over Layered Timbres
Using Program Changes
Timbre numbers 6 through 15 are accepted by the C-800 from the MIDI, and are
used to select layered timbres as shown in the chart below. Also, pressing
two timbre keys simultaneously sends the corresponding program change
function over MIDI, and may therefore be used for sending timbre numbers 6
through 15 to synthesizer instead of using procedure (2) above- For example,
if the C-800 receives timbre number 10 over MIDI, the organ and harpsichord
timbres will both be selected for layered play. On the other hand, pressing
the PIANO and ORGAN switches on the C-800 simultaneously will send a program
/timbre change number 7 to the connected equipment over MIDI.
PIANO ii/iilASPSl ORG^ii/i VIBES STRINGS
PI AMO — 6 7 8 9
HABPSl — — 1 0 1 1 1 2
ORGAN — — — 1 3 1 4
VIBES — — — — 1 5
STRINGS — — — — —
T r o u b l e s h o o t i n g
If the C-800 doesn t seem to be functioning properly, check the following points- If
the problem persists, call your local Korg Service Center.
Indicator lamps
don t light
Check that the AC plug is firmly connected to a properly
rated wall outlet-
No sound is heard
®!s volume set to 0?
<2)If in MIDI mode, is local off?
(Dis multi mode part 3 selected with no external sound
source connected?
-
18
-