Toshiba MA-205 - Manual (Page 27)

NOTES: 1. Even when the [AT/TL] key is set as "Amount Tender only" (Code
2), the key will function as Total Key without a tendered amount
entry if the sale total is negative.
2. The preceding O's may be omitted. As in this example, 1011 may
be entered instead of 001011.
3. If a value other than the designated above is ever entered in the
above operation, the maximum value of the designated will auto­
matically be regarded as the set value, (e.g.: If "3" is entered
for the %- rounding selection, it will result as the code "2"
(Round Down) is selected.
SAMPLE OPERATION:
To set the following requirements:
GT Print/ Non-print-- Print: 1
Consecutive No. Print-- Print: 1
[AT/TL]-- Amount Tender and Cash Total: 0
Time Display/Non Display, Time Print/Non-
print-- Display, Print: 1
Date Set and Print Order-- MONTH-DAY-YEAR : 0
%- Rounding Selection-- Round Off: 0
OPERATION: Turn the Mode Lock to SET.
Enter 001011 (or 1011),
depress [ST].
SETTING THE LISTING CAPACITY
Thank you
Call again
1 ? - 2 0 . - ? 6
0,01
an
0 0 4 5 §
1 1 - 2 3
The Listing Capacity (LC) is set in order to prevent an excessive amount
entry mistake by the operator at the earliest stage. For example, if the
LC is set to 5 digits and when the operator indexes 100000 ($1,000.00) for
a $100.00-priced commodity by mistake, the register will go into an error.
The LC to be set here will be effective in entering an amount through any
of the department keys in the "REG" mode.
CONDITION: After a reset
OPERATION: Mode Lock: SET
Enter one-digit code (1 to 7) to designate
the limit digits for a registration, and
depress [#]
NOTE: Code 0, 8, or 9 cannot be set.
It will result in an error if
ever attempted.
SAMPLE OPERATION:
To set "5 digits" for the Listing Capacity:
Mode Lock to SET.
Enter 5, depress [#]
Thank you
Call again
1 2
-
2
a - 8 6
if Q O 5
0 0 4 6 8
1 1 - 2 4
- 2 4 -