Toshiba MA-205 - Manual (Page 33)

This sets the hourly ranges for the report purpose. A maximum of 16 hourly
ranges may be set and the time division entry value must be 2-digit (i.e.
unit of one hour). When hourly ranges are set here, the sales data
registered in the REG mode will be processed into each hourly range memory
and the houry range sales data will be printed in the Read and Reset
reports, along with Department and Financial data.
CONDITION: After a reset
OPERATION: Mode Lock: SET
SETTING HOURLY RANGE TABLE
7 [X] Ending time of each hourly rangej
Enter 0 to 23 (max. 2 digits)
to indicate the hour value
(no minute value may be entered.)
m [AT/TL]
Repeat until all the required hourly
ranges are set. A maximum of 16 hourly
ranges may be set.
SAMPLE OPERATION:
To set the following hourly range table of
5 hourly ranges:
Mode Lock to SET.
from to Enter 7, depress [X]
22:00
(previous day)
10:00 Enter 10, depress [#]
10:00 12:00 Enter 12, depress m
12:00 15:00 Enter 15, depress m
15:00 22:00 Enter 22, depress m
Depress [AT/TL] to end,
NOTES: 1. In setting the hourly ranges, enter from the
early ending time to later ones correctly in
order.
2. Do not set an hourly range across 24:00.
If ever set, the sales data in that hourly
range will not be processed. The hourly
range from the last time division (ending
time) to the first time division will auto­
matically be set as the first hourly range,
as can be seen in the SAMPLE OPERATION.
3. In need of resetting the hourly range table
once set, operate as follows:
Mode Lock to SET, 7 [X] 0 [y>] [AT/TL]
4. In need of changing the hourly range table
once set, partially or entirely, do the
entire hourly range table setting operation
again.
- 3 0 -