To enter remote start mode – Chrysler 2014 200 Convertible - Owner Manual User Manual

Page 32

Advertising
background image

Remote Start Abort Message On Electronic Vehicle
Information Center (EVIC) — If Equipped

The following messages will display in the EVIC if the
vehicle fails to remote start or exits remote start prema-
turely:

• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Ajar
• Remote Start Aborted — Trunk Ajar
• Remote Start Aborted — Fuel Low
• Remote Start Aborted — System Fault

The EVIC message stays active until the ignition is turned
to the RUN position.

To Enter Remote Start Mode

Press and release the REMOTE START button
on the RKE transmitter twice within five sec-
onds. The vehicle doors will lock, the parking
lights will flash and the horn will chirp twice (if

programmed). Then, the engine will start and the vehicle
will remain in the Remote Start mode for a 15-minute
cycle.

NOTE:

• For security, power window operation is disabled

when the vehicle is in the Remote Start mode.

• The engine can be started two consecutive times (two

15 minute cycles) with the RKE transmitter. However,
the ignition switch must be cycled to the ON/RUN
position before you can repeat the start sequence for a
third cycle.

30

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

Advertising