Casio XJ-S43W - Manual (Page 39)

39
To replace the lamp
Important!
z When replacing the lamp, use the special screwdriver that comes with the
replacement lamp. The projector does not come with a screwdriver.
1 Turn off the projector and unplug its
AC power cord.
2 Wait for about 60 minutes to allow
the projector’s current lamp to cool
down completely.
3 Turn over the projector and place it
on top of a desk or on some other
stable surface.
4 Loosen the lamp cover screw, and
then remove the lamp cover.
5 Loosen the three screws indicated by
the
marks.
6 Pull up on the handle or ribbon to
remove the lamp cartridge.
7 Insert the new lamp cartridge as far
as it will go, as shown in the
illustration.
z After inserting the lamp cartridge,
stow the ribbon as shown in the
illustration in step 5.
Lamp cover
Lamp cartridge
Make sure the grooves of the lamp cartridge align
with the grooves of the lamp housing.