Dodge 2012 Ram - Manual (Page 194)

The HomeLink
௡ buttons that are located in the overhead
console designate the three different HomeLink ௡ chan-
nels.
NOTE: HomeLink ௡ is disabled when the Vehicle Secu-
rity Alarm is active.
Before You Begin Programming HomeLink
ா
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink
௡
system.
Erase all channels before you begin programming. To
erase the channels place the ignition in the ON/RUN
position and press and hold the two outside HomeLink
௡
buttons (I and III) for up 20 seconds. The Electronic
Vehicle Information Center (EVIC) will display “CLEAR-
ING CHANNELS”. Release the buttons when the EVIC
displays “CHANNELS CLEARED”.
HomeLink
௡ Buttons
192 UNDERSTANDING THE FEATURES OF YOUR VEHICLE