Dodge 2012 Ram User Manual

Page 438

Advertising
background image

Snow – In heavy snow or for additional control and

traction at slower speeds, shift the transmission to a
low gear and shift the transfer case to 4L (Low Range)
if necessary. Do not shift to a lower gear than neces-
sary to maintain headway. Over-revving the engine
can spin the wheels and traction will be lost. If you
start to slow to a stop, try turning your steering wheel
no more than a

1

4

turn quickly back and forth, while

still applying throttle. This will allow the tires to get a
fresh

ЉbiteЉ and help maintain your momentum.

CAUTION!

On icy or slippery roads, do not downshift at high
engine RPMs or vehicle speeds because engine brak-
ing may cause skidding and loss of control.

Mud – Deep mud creates a great deal of suction

around the tires and is very difficult to get through.
You should use 4L (Low Range) with a gear low

enough to maintain your momentum without shifting.
If you start to slow to a stop, try turning your steering
wheel no more than a

1

4

turn quickly back and forth

for additional traction. Mud holes pose an increased
threat of vehicle damage and getting stuck. They are
normally full of debris from previous vehicles getting
stuck. As a good practice before entering any mud
hole, get out and determine how deep it is, if there are
any hidden obstacles and if the vehicle can be safely
recovered if stuck.

Sand – Soft sand is very difficult to travel through

with full tire pressure. When crossing soft sandy spots
in a trail maintain your vehicle’s momentum and do
not stop. The key to driving in soft sand using the
appropriate tire pressure, accelerating slowly, avoid-
ing abrupt maneuvers and maintaining the vehicle’s
momentum. If you are going to be driving on large soft
sandy areas or dunes, reduce your tire pressure to a
minimum of 15 psi (103 kPa) to allow for a greater tire

436

STARTING AND OPERATING

Advertising