Drawmer TS2 Dual Tube Compressor - Manual (Page 6)

Tube Station 2 OPERATORS’ MANUAL 4
DIGITAL MODULE INSTALLATION
The Digital modules are designed only for operation within a Drawmer Tube Station.
Under NO circumstances should the module be installed into any other
manufacturers’ or custom device.
Full anti static handling precautions must be followed to prevent
damage to sensitive circuitry.
To Install the module:
a: Disconnect the mains power cable from the unit.
b: Remove the top cover.
c: Remove the blanking panel from the rear of the unit.
d: Slide the Digital Module through the rear panel.
e: Fasten the Digital Cover Plate to the rear panel.
f: Fasten the Digital PCB onto the three supporting posts.
g: Connect the flexi strip into the holder on the main board.
h: Replace the top cover.