Fieldmann FZD 4010-E - Manual (Page 17)

17
OPERATION MANUAL GARDEN SHREDDER
EN How to handle the product?
The interlock switch gets activated under the following circumstances:
- build-up of shredded material around the shredder roller.
- the engine capacity overload.
- processed material resists the shredder roller blades.
If the interlock switch was activated, switch-off the shredder and disconnect from the mains.
- Unscrew the control of the reamer at the bottom of the head and open the upper part.
- Remove the debris or obstacle from the shredding zone.
- Put the upper part back on and tighten the reamer control.
- Let the engine at standstill for several minutes to cool down.
- Re-connect to the mains and push the interlock switch.
- To turn on the shredder again, pres the main switch (10) (Fig. 2) – position “I”.
WARNING! NEVER demount the pressure plate cover adjustment knob without switching-
off the main switch („On/Off“ button) and disconnecting the power supply cable plug from
the mains first.
WARNING! The shredder will stop shredding within 5 seconds after switching-off by
pushing the main switch.
The use of the plunger
The plunger serves as an aid when filling the feed hopper with small material (for instance
small twigs, leafage, other garden waste and greens).
Fill-in the feed hopper (Fig. 6)
Press the material through a plunger (12) (Fig. 7) towards the blade disk (Fig. 17).
Wait until the material is shredded and only then insert the next batch.
WARNING! Never allow your fingers inside the feed hopper chute!
WARNING! Never use the equipment without the feed hopper!
WARNING! Do not lean over the feed hopper!
How to collect the shredded material?
Before moving the bag closer or farther, switch-off the drive unit.
For collecting the material, you can use the collection bag (if it is a part of delivery) or you can
place the shredder on a sheet in order to collect the shredded material
If you use the collection bag, you need to attach both hooks of the bag to the discharge chute.
WARNING! Do not cover ventilation slots of the machine body by the collection bag or
shredded material.