Fieldmann FDV 1001-A - Manual (Page 12)

EN 11
FDV 1001-A
Mainetance and storage
6. MAINTENANCE AND STORAGE
Maintenance
ATTENTION: Disconnect the charger if you will not be using it for a long time, if you are changing
the tool or performing maintenance on the tool.
This tool does not require any special maintenance. The same applies to the electrical parts of the tool.
Check whether the device is showing signs of wear.
If the charger is damaged (cover, conductors or connector), immediately arrange its replacement at
the vendors service centre.
Regular care for the machine will ensure not only a long lifetime and performance
Before use always visually check for worn or damaged parts.
Replace damaged or worn parts. To ensure that the machine always remains balanced, always
replace the entire set of the worn or damaged tools.
Worn or damaged machine parts may only be replaced at an authorised service centre or the vendor.
Before cleaning disconnect this product from the power source.
To clean the plastic parts of the product, use a soft cloth dipped in lukewarm water. Do not use
aggressive cleaning products and solvents as this could damage the surface of the appliance.
Do not clean the machine under running water or submerge under water.
After changing the working tool, check that the working tool is secured in its storage position.
Do not use working tools that are not proportioned for placement into the tang in the magazine.
Do not overload the electric power tool. Use the right type of electric power tool for your work. When
the correct electric power tool is used, the work result will be performed better and more safety.
If it is not possible to turn the main trigger switch on or off, do not work with the tool. All electric
power tools with a trigger switch that do not work are dangerous and must be repaired.
If you are not working with the tool, store it out of the reach of children and prevent persons not
informed about the operation of the tool or this user's manual to work with the tool. An electric
power tool in the hands of an unqualifi ed person is dangerous.
Perform maintenance on the tool. Check for deviation or blockage of the moving parts, damage
of individual parts and other factors which could affect the operation of the tool. If the tool is
damaged, have it repaired before using it. Many accidents are caused by neglected maintenance
of a tool. Properly maintained cutting tools with sharp cutting edges are less prone to jamming in
a workpiece and are easier to handle.
Maintain cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less prone to jamming in a workpiece and are easier to handle.
Use electric power tools, accessories, working tools, etc. according to these instructions in a manner
appropriate for the given type of electric power tool and take into consideration the work conditions
and the type of work that you will be performing. Using electric power tools for purposes other than
those for which they were designed may be dangerous.
Damaged switches must be replaced at an authorised service centre or the vendor. Do not use
electric power tools that cannot be turn on and off.
Do not leave electric power tools turned on without supervision. Always turn the tool off and wait
for it to come to a complete stop before putting it down.
Use hearing protection. Excessive noise levels may cause hearing damage.