Fieldmann FDV 1001-A - Manual (Page 7)

EN
CORDLESS DRILL USER'S MANUAL
6 Instructions for proper use
4. INSTRUCTIONS FOR PROPER USE
Fully charge the battery before fi rst use. Ensure that the used drill bits and extension pieces are
designed for the given task and that they are securely fastened. Check that the direction switch is set
in the position for the desired rotation direction.
NOTE: Always ensure that the battery is removed before changing working tools or before
performing adjustments.
ATTENTION: Dust created during grinding, cutting, drilling and other work tasks may in some
cases contain chemical substances, which are known to cause health problems. Some examples
of these chemical substances are:
a) Lead from lead-containing paints.
b) Cement and other construction products.
c) Chemically treated wood.
Screwing
1. An appropriate opening should be drilled into the workpiece before screws are screwed into wood.
This will prevent the movement of the screw and tool on the surface of the workpiece, which could
damage it.
2. We recommend that for screwing you use slow rotation speeds.
3. Insert the screwing bit into the head of the screw and carefully screw it into the opening.
4.
We recommend tightening using the lowest torque value and to gradually increase the torque value
until the desired torque level is achieved.
Drilling
1. Do not use the torque control when drilling into wood. Select the standard drilling position.
2. When drilling into wood use wood drilling bits.
3. When drilling into metals or plastics use metal drilling bits.
4. When drilling into soft wood the drill should run at maximum speed.
5. When drilling into hard wood the drill should run at a lower speed.
LED Battery charge level indicator light (see pic. 6)
The LED indicator light is used to show the battery charge level. When the tool is turned on by the
trigger switch the LED light (no. 2) comes on. If all the LED diodes are on, the battery is suffi ciently
charged. If only a single LED diode is on, the battery is virtually fl at and must be charged immediately.
Lighting of the working area (see pic. 6)
The LED lighting (no. 1) is turned on when the trigger button is pressed and lights up the area that is
being drilled or screwed. Turning off the trigger switch also turns off the LED lighting of the working
area.