FloAire F-D Installation - Manual (Page 32)

August 2013 Rev. 1 32
Start-Up and Maintenance Documentation
START-UP AND MEASUREMENTS SHOULD BE PERFORMED AFTER THE SYSTEM HAS BEEN
AIR BALANCED AND WITH THE HEAT ON (Warranty will be void without completion of this form)
Job Information
Job Name Service Company
Address Address
City City
State State
Zip Zip
Phone Number Phone Number
Fax Number Fax Number
Contact Contact
Purchase Date Start-Up Date
Heater Information
Refer to the start-up procedure in this manual to complete this section.
Name Plate and Unit Information
Field Measured Information
Model Number Motor Voltage
Serial Number Motor Amperage**
Motor Volts RPM
Motor Hertz Burner Differential Pressure in. w.c.
Motor Phase Max Burner Pressure in. w.c.
Motor FLA Min Burner Pressure in. w.c.
Motor HP Pilot Flame Signal VDC
Blower Pulley Low Fire Flame Signal VDC
Motor Pulley High Fire Flame Signal VDC
Belt Number Gas Type
Gas Type High Fire Inlet Gas Pressure in. w.c.
Min. Btu/Hr Low Fire Manifold Gas Pressure in. w.c.
Max. Btu/Hr High Fire Manifold Gas Pressure in. w.c.
Thermostat Set-Point
Temperature Control Discharge
Space
Airflow Direction Correct
Incorrect
** If measured amps exceed the FLA rating on the nameplate, fan RPM must be reduced.
Maintenance Record
Date Service Performed
Factory Service Department
Phone: 1-866-784-6900
Fax: 1-919-554-9374