FloAire FAV - Manual (Page 4)

4
WARRANTY
This equipment is warranted to be free from defects in materials and workmanship, under normal
use and service, for a period of 12 months from date of shipment. This warranty shall not apply if:
•
the equipment is not installed by a qualified installer per the manufacturer’s installation
instructions shipped with the product
•
the equipment is not installed in accordance with federal, state and local codes and
regulations
•
the equipment is misused or neglected
•
the equipment is not operated within its published capacity
•
the invoice is not paid within the terms of the sales agreement
•
the Start-Up Checklist has not been filled in by a qualified technician and returned to the
Factory Service Department
The manufacturer shall not be liable for incidental and consequential losses and damages
potentially attributable to malfunctioning equipment. Should any part of the equipment prove to
be defective in material or workmanship within the 12-month warranty period, upon examination
by the manufacturer, such part will be repaired or replaced by manufacturer at no charge. The
buyer shall pay all labor costs incurred in connection with such repair or replacement. Equipment
shall not be returned without manufacturer’s prior authorization and all returned equipment shall
be shipped by the buyer, freight prepaid to a destination determined by the manufacturer.
NOTE TO INSTALLER
Please complete and return the
Start-UP Checklist on the back of this manual to validate warranty
INSTALLATION
It is imperative that this unit is installed and operated with the designed airflow, gas, and electrical
supply in accordance with this manual. Any variance to these instructions may cause the unit to not
perform to specifications and may cause severe damage to the unit or jobsite. Please call the service
department at 866-784-6900 for assistance on warranty issues and technical support.
Inspection on Arrival
1. Inspect unit on delivery
2. Photograph any visible damage
3. Report any damage to the delivery carrier
4. Request a written inspection report from the
Claims Inspector to substantiate claim
5. File claims with delivery carrier
6. Check unit’s rating plate to verify proper
electric and fuel type to meet job
requirements
7. Compare unit received with description of
product ordered
Unit Location
1. Do not locate any gas-fired equipment near
corrosive or explosive vapors such as
chlorinated or acid vapors
2. Avoid overhead power lines, or other utility
access to prevent accidental contact or
damage.
3. Provide clearance around installation site to
safely rig and lift the equipment into its final
position onto adequate supports. Refer to
the manufacturer’s estimated weights.
4. Consider general service and installation
space when locating the unit.
5. Locate the unit close to the space it will
serve to reduce long, twisted duct runs.
6. Do not allow air intake to face prevailing
winds. Air flow switch may trip in high winds.