Flyzone FLZA3004 - Manual (Page 5)

5
ASSEMBLY
Install the Receiver (Rx-R Only)
❏
1. Cut strips from the included, adhesive-backed hook-
and-loop material. Stick one to the back of your receiver and
the other inside the fuselage as shown—the softer, “loop”
side goes on the receiver and the rougher, “hook” side goes
in the fuselage.
(White/Orange)
Receiver
+ (Red)
− (Black/Brown)
❏
2. Connect the servos and the Y-harness to the receiver
as shown.
Channel 1 (aileron) – dual Y-harness
Channel 2 (elevator) – elevator servo
Channel 3 (throttle) – electronic speed control (ESC)
Channel 4 (rudder) – rudder servo
❏
3. Mount the receiver to the Velcro ® strip in the fuselage.
Hook Up the Elevator and Rudder
Rx-R, Tx-R, and RTF
❏
1. Flex the elevator up and down and the rudder back and
forth several times to break them in.
❏
2. Fit the vertical stabilizer (fi n) into the horizontal stabilizer
(stab).