Flyzone FLZA4300 - Manual (Page 4)

4
BEFORE YOU BEGIN
Before you begin assembling your Cessna 350 Corvalis,
thoroughly read the instruction manual included with the
battery charger. Also familiarize yourself with the following
lithium polymer battery cautions. When satisfi ed with your
understanding of the battery charge process and safe
handling of LiPo batteries, charge your fl ight battery so it will
be ready to use when your assembly is complete.
LITHIUM BATTERY HANDLING AND USAGE
WARNING!! Read the entire instruction sheet included
with your battery charger. Failure to follow all instructions
could cause permanent damage to the battery and its
surroundings, and cause bodily harm!
• ONLY use a Li-Po approved charger. NEVER use a
NiCd/NiMH peak charger!
• NEVER charge in excess of 4.20V per cell.
• ONLY charge through the “charge” lead. NEVER charge
through the “discharge” lead.
• NEVER charge at currents greater than 1C.
• ALWAYS set charger’s output volts to match battery volts.
• ALWAYS charge in a fi reproof location.
• NEVER trickle charge.
• NEVER allow the battery temperature to exceed 150° F
(65° C).
• NEVER disassemble or modify pack wiring in any way
or puncture cells.
• NEVER discharge below 3.0V per cell.
• NEVER place on combustible materials or leave
unattended during charge or discharge.
• ALWAYS KEEP OUT OF REACH OF CHILDREN.
ASSEMBLE THE MODEL
❏
1. Insert the wing joiner into the wing pocket of one wing
panel. Be sure that the “V” shape of the joiner points toward
the underside of the wing.
❏
2. Fit the other wing panel onto the wing joiner.
❏
3. The aileron and fl ap pushrod wires must pass through
the holes in the screw lock connectors when the wing panels
are joined together.