Flyzone FLZA4314 - Manual (Page 10)

10
Mount the Wing
Before mounting the wing, we have found it is helpful to
label the servo wires for the ailerons, fl aps and retracts. This
takes the guesswork out of reconnecting the servo wires to
the receiver. We use a small piece of masking tape on each
wire and label the ailerons ‘A’, the fl aps ‘F, and the retracts ‘R’.
❏
1. Connect the aileron, fl ap and retract servos to the receiver.
❏
2. Insert the two wing dowels in the leading edge of the
wing into the two holes at the front of the wing saddle.
❏
3. Make sure that the servo wires do not interfere with the
rudder and elevator servos or get caught between the wing
and the wing saddle as the wing is seated on the fuselage.
❏
4. Secure the wing to the fuselage with a 6
× 25mm nylon
wing bolt.
Install the Propeller
❏
1. Insert the collet prop adapter through the engine louvers.
❏
2. Install the collet prop adapter on the motor shaft. Slide
the propeller on the prop adapter and secure it with the prop
washer and prop nut. Align the propeller so that the slots in
the engine louver are between the propeller blades. Then,
tighten the prop nut with a wrench.
❏
3. Position the spinner back plate over the propeller. Then,
secure the spinner cone and back plate to the prop adapter
with a 3
× 25mm machine screw.