Flyzone FLZA4314 - Manual (Page 5)

5
Battery Charging Precautions
● Be careful to avoid overcharging the battery. Only use a LiPo
approved charger. Never use a NiCd/NiMH peak charger.
● Remember to check the temperature of the battery during
the charge. The battery should not get hot. If it does, unplug
the battery from the charger.
● Charge the battery at a maximum charge rate of 1.8 amps.
A higher charge rate will cause the battery to get hot.
● Never place the battery on combustible material or leave it
unattended while charging.
● Never charge the battery in the plane.
● We recommend that a balancing charger be used to charge
the battery. A properly cared for battery will last a long time. If
the battery pack is continually charged without balancing the
individual cells, the life of the battery pack will be shortened.
Battery Recycling
Attention: The Focke-Wulf Fw-190 is powered by a
rechargeable battery. At the end of the battery’s useful life,
under various state and local laws, it may be illegal to dispose
of the battery into the municipal waste system. Check with your
local solid waste offi cials for details in your area for recycling
options or proper disposal. We encourage contacting your
local recycling center for more information.
Install the Receiver
If you are assembling the Fw-190 RTF, skip to the next section
and start at
Install the Stabilizer .
❏
1. Plug the elevator servo into channel-2 on the Tactic receiver.
Plug the rudder servo into channel-4 on the Tactic receiver.
❏
2. Plug the throttle into channel-3 on the Tactic receiver.
❏
3. Peel the backing from one side of the double-sided tape.
Attach it to the back of the receiver. Peel the backing from the
other side of the double-sided tape and attach it to the bottom
of the servo compartment.
Install the Stabilizer
❏
1. Remove the foam fi ller piece from the horizontal stabilizer
opening.