Flyzone FLZA4314 - Manual (Page 7)

7
❏
3. Position the throttle stick (left stick) to idle (all the way
down) and switch on the transmitter. The power indicator light
should be glowing a steady red. A fl ashing red light and an
audible tone indicates low voltage. If this happens, replace
the batteries before connecting the fl ight battery.
❏
4. Center the aileron, elevator, throttle and rudder trims on
the transmitter by listening to the beeps. You will hear a low,
short beep each time you bump the trim. When you hear one
high, short beep the trim is centered. Experiment running the
trim to the limits a few times to familiarize yourself with the
trims. When fi nished, return all the trims to center.
❏
5. With the transmitter still switched on, connect the LiPo
motor battery to the electronic speed control. The motor will
produce a low tone. Moving the right stick on the transmitter
up and down will move the elevator on the plane up and down.
If the motor does not beep and the elevator does not move,
the receiver will need to be bound to the transmitter.
❏
6. To bind the receiver to the transmitter, remove the receiver
from the plane. Make sure the throttle stick is down in the idle
or off position and the transmitter is switched on. Insert a
small screwdriver or paperclip through the hole marked “Bind”
and press the pushbutton until the LED on the receiver glows
red and then turns off after about one second. Then, release
the bind button. If the binding is successful, the LED on the
receiver will fl ash once and then remain ON.
❏
7. Make sure the motor brake function in the ESC is
deactivated. When you advance the throttle stick, the motor
should turn. When you bring the throttle stick all the way
back down, the motor should come to a coasting stop. If the
motor stops quickly, the brake is on. To deactivate the brake,
disconnect the motor battery, but leave the transmitter on.
Advance the throttle stick and throttle trim all the way up.
Reconnect the battery and listen for one beep. Bring the throttle
stick and the throttle trim all the way back down and listen
for one more beep. Now the motor brake function is disabled.
The procedure for activating the brake is the same, except
the motor will beep twice instead of once.
CAUTION: Perform the following steps without the propeller
mounted to the motor. Do not install the propeller until
instructed to do so.
Adjust the Control Surfaces
❏
1. Remove the 2.5
× 5mm machine screw in the screw lock
connector on the elevator servo. Center the elevator and apply
a small drop of threadlocker to the threads of the screw. Hold
the screw lock connector with a needle nose pliers and reinstall
the screw in the screw lock connector, tightening it against
the elevator pushrod. Move the elevator stick, checking that
the elevator moves in the correct direction.
❏
2. Follow the same procedure to center the rudder.