Flyzone FLZA3300 User Manual
Page 9
9
❏
2. Remove the screws that secure the aileron servo arms.
Pull the servo arms off the servos and move the pushrod
wires to the outer holes of the arms (toward the wing tips).
Reinstall the arms onto the servos and replace the screws.
❏
3. Repeat this procedure for the pushrod wires connected
to the elevator and rudder servo arms.
❏
4. Insert the wing joiner tube through the joiner tube
holes in the fuselage.
❏
5. Slide the wing panels onto the wing joiner. The aileron
servo leads should fi t through the slots in the fuselage sides.
Be sure the panels are fully seated against the fuselage.
❏
6. Connect the Y-harness to the aileron servo leads
and also to channel 1 of the receiver. Test fi t the low wing
confi guration canopy hatch to the fuselage and bolt it in place.
NOTE:
The low wing confi guration will require you to
readjust your control surface trims.
Be prepared
for
this on your fi rst fl ight.