Flyzone HCAA27 - Manual (Page 4)

4
ASSEMBLE THE TAIL
❏ 1. Remove all of the components from the plastic
packaging and lay them out on your work surface.
❏ 2. Install the “U” shaped threaded wire into the
plastic fi n holder as shown. The longer end of
the wire should be installed at the end of the fi n
holder that has the angled edge.
❏ 3. Slide the wires through the holes in the top of
the horizontal stab, sliding the plastic fi n holder
fl ush with the horizontal stab.
❏ 4. Slide the wire through the holes in the top of
fuselage, pressing the horizontal stab onto the top
of the fuselage.
❏ 5. Install a plastic nut onto each threaded end of
the wire until the horizontal stabilizer fi ts snug to
the fuselage.
❏ 6. Install the fi n into the fi n holder.