Flyzone HCAA1960 - Manual (Page 4)

❏ 1. Remove the fuselage from the packaging. Be careful
when removing the fuselage from the packaging as the
control wire that is preinstalled in the fuselage is
connected to the V-tail. Lay the parts out on a table
ensuring the control wires are not intertwined or twisted
together. Untie the red antenna wire and let it hang
freely. Do not cut off excess antenna wire!
❏ 2. Align the two loops of the tail wheel wire with
the holes at the back of the fuselage on the bottom.
Push the two thumb screws through the two loops in
the tail wheel wire and into the V-tail tray at the back
of the fuselage tube. Fold the V-tail into a shallow “V”
shape and press it into the angled tray allowing the
thumb screws to properly position the tail on the tray.
❏ 3. Locate the red plastic V-tail brace and align the
pegs with the six holes in the V-tail. Secure the brace
by turning the thumb screws drawing the brace tight
against the tail. If you have difficulty tightening the
brace, confirm that the thumb screws are aligned
with the two screw holes in the brace. Confirm that
the control wires are not pinched underneath the
brace. Correct if necessary.
❏ 4. Locate a small rubber band included with the
Red Hawk. Hook the rubber band to the left elevon
control hook. Loop the rubber band around the front
of the V-tail tray and connect the rubber band to the
right control hook.
ASSEMBLE THE TAIL
4