Flyzone HCAA1960 - Manual (Page 5)

❏ 5. Using the adjustment knobs on the control
horns, adjust each control line until the elevon
surfaces are level with V-tail fins.
❏ 6. If at any time the control wire needs to be
rethreaded onto the adjustment knobs, rotate the
knob until the small hole in it aligns with the outer
hole in the control horn.
❏ 7. Feed the wire through the hole in the control
horn and then through the hole in the adjustment
knob. Pull approximately 3/4" [19mm] of excess wire
through the knob.
❏ 8. While holding the excess wire taught, rotate the
knob so that the wire is reeled in. A few rotations will
then keep the wire tight on the knob. Adjust the knob
until the elevon is level.
❏ 1. Locate the main landing gear. Squeeze the
wheels together as shown in the picture and push the
center of the landing gear wire into the slot as far as
it will go into the underside of the fuselage body. Let
go of the wheels and they will spring back into
position securing the gear to the plane.
INSTALL THE MAIN LANDING GEAR
5