Flyzone HCAA1961 - Manual (Page 5)

Locate the main landing gear. Remove the thumb screw
and insert the landing gear into the slot on the fuselage
as shown.
Replace the thumb screw to hold the main gear in place.
Follow the same procedure to install the nose gear
as shown.
The included 12V DC Peak Charger can be plugged directly
into an automobile 12 V receptacle. The charger can also be
powered with 120V AC by using the AC wall adapter. The
AC wall adapter can be plugged into any household outlet
and when connected to the charger, it provides a
convenient way to recharge the SkyFly battery when a 12V
source is unavailable. NEVER PLUG THE BATTERY
DIRECTLY INTO THE AC WALL ADAPTER!
• To begin charging the battery pack, plug the 12v peak
charger into your automobile or 12V AC outlet (using
the AC adapter).
• Connect the pack to the white connector on the charger.
The battery can only connect to the 12v charger in one
direction, do not force it. If using the charger in an
automobile, Do not have the engine running -
Overcharging the battery may result!
• Press the start/stop button on the charger to initiate peak
charge. The red light on the charger will illuminate
indicating that charge has begun. You can press the
start/stop button at any time during peak charge to
terminate the process. The red light will go out indicating
that peak charge has been stopped.
The peak charger will automatically detect when the battery
pack is fully charged and terminate peak charge. The red light
will go out when this has occurred. Typical charge time for a
depleted pack is approximately 1 hour. The actual time the
charger takes to fully charge the SkyFly battery pack may vary.
CHARGING THE BATTERY PACK INSTALL THE LANDING GEAR
5