Flyzone HCAA1961 - Manual (Page 7)

Slide the front of the wing under the canopy and position
the wing flat and centered on the fuselage. Secure the wing
with two rubber bands, straight from the front to rear pegs.
Attach two additional rubber bands diagonally over the top
of the wing. Only use four rubber bands to attach the wing
to the fuselage.
Your model comes out of the box "factory balanced." The
following information takes you through the process of
balancing the model should you need to do so.
Use a fine-point felt-tip pen to mark the balance range on both
sides of the bottom of the wing according to the
measurements shown in the photo. Note that the
measurements are from the front, or leading edge of the wing.
With the battery in place, lift the model with your
fingertips between the lines under the wing. Position
your fingertips where necessary to get the model to sit
level, or “balance”. If your fingertips are between the
lines, the SkyFly is ready to fly.
If the model balances with your fingertips ahead of the
lines, weight will have to be added to the tail to get it to
balance. Tail weight may be stuck to the bottom of the
stabilizer at the center. Be sure that any added weight
does not interfere with the operation of the elevator.
If the model balances with your fingertips behind the
lines, weight will have to be added to the nose to get the
model to balance. Nose-weight may be stuck to the
upper inside of the fuselage just in front of the hole for
the canopy retaining tab. Stick-on lead weight may be
purchased from your local hobby shop.
Stick on as much weight as required to get the model to
balance when lifted by your fingers between the lines. If
you added any weight, recheck the balance.
BALANCE THE MODEL
ATTACH THE WING
7