Flyzone HCAA1961 - Manual (Page 8)

The SkyFly transmitter is equipped with an
Expert/Beginner switch. When this switch is in the
"Beginner" position, the transmitter will automatically
combine or "mix" a small amount of up elevator when
rudder input is provided to help maintain altitude when
turning. In "Expert" mode, there are no flying aids or
"mixing" to help the pilot.
Locate the antenna and screw it into the top of
the transmitter.
The transmitter that controls your airplane requires power,
in the form of eight “AA” batteries. To install the batteries,
remove the battery cover on the back of the transmitter.
Pull the battery holder out of the transmitter case and
install eight new “AA” batteries, following the diagram
on the holder.
Reinsert the battery holder in the transmitter case. Reinstall
the battery cover on the back of the transmitter case.
Switch on the transmitter and check the LED on the front of
the transmitter. If the LED is green, it is safe to fly. If the LED
is flashing red and beeping repeatedly, you need to install
fresh batteries. Note: The transmitter will always beep twice
when first turned on.
Note: The SkyFly transmitter is equipped with a charge
jack that allows NiCd or NiMH batteries to be charged
without removing them from the transmitter. In order to
use the charge jack, a separate charge jack conversion
kit (HCAP6010) must be purchased. The kit comes with
(8) "AA" rechargeable NiCd batteries and a 2-3 hour
quick charger.
Be sure your transmitter has fresh “AA” batteries
installed (not included). Turn on the transmitter and
center the trims tabs. Staying clear of the propeller,
remove the canopy from the SkyFly and connect the
battery to the receiver/ESC. If necessary, adjust the
control surfaces with the adjustment knobs to center
them or use the trim levers on the radio.
Using the adjustment knobs on the elevator and rudder
control horn, adjust each control line until the control
surfaces are level with the fin and stabilizer.
If at any time the control wire needs to be rethreaded onto
the adjustment knobs, rotate the knob until the small hole
in it aligns with the outer hole in the control horn.
CHECK THE CONTROL DIRECTIONS
CAUTION
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (NiCd) batteries.
PREPARE THE TRANSMITTER
8