Futaba 14MZ - Manual (Page 70)

●Return to Linkage Menu
● Touch the [Dial Monitor] button in the Linkage
Menu to call the setup screen shown below.
Dial Monitor LDisplays the position of the dials, slider levers, and digital trim.
Digital Trim Position display (T1-T6, CD)
The Dial Monitor displays the current position
and the operation step amount of each Digital Trim.
VR and slide lever position display (LST, LS, LD,
RD, RS, RST)
Displays the current position (black ) and last
operating position (green ) of the VRs and slider
levers.
Knob and Lever Position display
(LD, RD, LS, LST, RS, RST)
The Dial Monitor displays the current position
and last operation position of each knob and lever.
Although neither knob nor lever can hold the last
operation position because of they are “analog”
type, the position data during the last operation is
memorized in the model memory. By moving the
knob and lever to the position displayed on this
monitor, the last operation position is recalled.
Recalling Dial Position
(LST, LS, LD, RD, RS, RST)
The dial position data at the last operation is
displayed for each knob and lever in this monitor.
(Green arrow)
1. Move the black arrow (current position)
to the green arrow position by operating
the desired knob or lever to recall the last
operating position.
70 <Linkage Menu>