Futaba 14MZ - Manual (Page 79)

Setting method
CTRM mode: Maximum amount of change
near center by center trim operation. When the
adjustment range (Range) value is made small, trim
is active only near the center.
NORM mode: Normal trim (parallel movement
trim) operation. When the adjustment range (Range)
value is made small, trim is active only near the
center. Needle high trim works as high trim based
on the center. This operation is similar to reverse
ATL trim.
1. An acceleration function can be set. This
function is used when there are symptoms
of the mixture being either too rich or
too lean, which would be generated by
sudden operation of the throttle stick.
An acceleration (ACLR) function and
deceleration (DCLR) function, which
temporarily increase and decrease the fuel
supply at acceleration and deceleration,
can be set.
2. The return time after operation (Dump) can
be set for both setting at acceleration (High)
and setting at deceleration (Low).
3. A needle throttle cut function can be set.
4. Operation linked with the throttle hold
functions (Cut and Idle), Throttle Cut function,
and Idle Down function is possible.
5. The needle side cut position can be set. Set it
to the fuel side full open position.
When the MIX mode is selected, the throttle
curve set data becomes the mixing master.
In the UNMIX mode, the throttle stick position
becomes the mixing master.
● Return to Model Menu
● Touch the [Fuel Mixture] button in the Model Menu to
call the setup screen shown below.
Fuel Mixture Dedicated mixing used in needle adjustment of engines which use a fuel mixture
control carburetor. [Airplane, helicopter]
This function is dedicated mixing used in needle
adjustment of an engine that uses a fuel mixture
control carburetor.
*The needle channel is assigned to CH9 as a default.
● Operation curve setting
(For a description of the setting method, see the description at the
back of this manual.)
79 <Model Menu (Common Functions)>