Philips CCX092AT - Manual (Page 49)

Helpful Hints (confd) 49
The remote control is not available, or the remote control will not access the pop up menu.
• Use the buttons on the front panel of theTV/VCR to access the pop up menu (page 20).
TV/VCR power shuts off after 15 minutes.
• To save energy, the TV/VCR will shut itself off after IS minutes when it is on a channel that is not receiv­
ing a broadcast signal (for example, a station tiiat has gone off the air for the night),This is normal.
Channel reception is poor.
• Check connections, then program channels again (page 10).
TV/VCR does not have a picture.
• Adjust the antenna (pages six - seven).
• Connect the antenna or cable directly to theTV/VCR.
• Adjust theTV/VCR picture controls (pages 24 - 25).
TV/VCR has poor sound or no sound.
• Adjust the volume.
• Press the MUTE button to restore the volume.
Tape playback is poor or tape is destroyed.
• Adjust the tracking. Details are on page 45.
• If moisture has accumulated in your TV/VCR, keep the power on for at least two hours, but do not try
to play a tape. Deto//s are on page 48.
TV/VCR does not display closed captioning.
• Cancel Counter Only mode. Detoi/s are on page 26.
• Make sure closed captioning is available for the program. Refer to the TV listings in your local newspaper.
Remote control does not operate TV/VCR.
• Aim the remote control directly at the TV/VCR’s remote sensor. Details are on pages five and 20.
• Remove all obstacles between the remote control and theTV/VCR.
• Inspect and replace the batteries in the remote control. Detai/s are on page five.
Number buttons won’t work for channels above 69.
• Select CABLE from the INPUT section of the pop up menu, then let tiie TV/VCR program the channels.
Deta/7s ore on page 10.
TV/VCR can’t receive channels above 13,
• Select CABLE from the INPUT section of the pop up menu, then let theTV/VCR program the channels.
Details are on page 10.
A tape can’t be inserted into the TV/VCR.
• Insert the tape window side up, with the record tab facing you,
• Make sure a tape isn’t already in theTV/VCR by pressing the STOP/EjECT button on theTV/VCR.
• Gently push on the center of the tape. Never force a tape into theTV/VCR.
• Moisture may be present in theTV/VCR. If “DEW PROTECTION PLEASE WAIT’ appears on-screen, you
may not be able to Insert a tape for several hours. Details are on page 48.
A tape can’t be removed from theTV/VCR.
• Make sure the power plug is completely connected to an AC (alternating current) outlet.
• If a timer recording is programmed, turn on the TV/VCR power, then eject the tape. Be sure to insert a
tape and turn off theTV/VCR power for the timer recording.
TV/VCR ejects the tape when you try to start a recording.
• Make sure tiie tape has a record tab. Deto//s are on page five.
The cylinder rotates when theTV/VCR is in Stop mode.
• To enable the quick play mechanism, the cylinder will rotate for about five minutes.This is normal.
Daylight-Saving Time
• When Daylight-Saving Time is ON, the clock time will change automatically as follows: on the first Sunday
of April, from 2 am. to 3 a.m.; on the last Sunday of October, from 2 am. to I am.
• When programmed timer recordings start between 2 am. and 2:59 a.m. on the first Sunday of April, the
TV/VCR will start recording at 3 am. (summer time).
• When programmed timer recordings end between 2 am. and 2:59 am. on the first Sunday of April, the
TV/VCR will stop at 3 am.
• When using this feature, a program that occurs during the spring time change may not record complete­
ly. Adjust the start and stop times accordingly.
Automatic clock setting won’t work.
• Disconnect the car battery cord from the DC 13.2V jack. Instead, use the AC 120V jack to supply stan­
dard electrical power (page 7).