Switching on and off, Adjusting volume and sound, Improving radio reception – Philips AZ 1203 User Manual
Page 7: Basic functions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BASIC FUNCTIONS
Switching on and off
Set the POWER slider to the desired sound source:
CD, TUNER, or TAPE.
The set is switched off when the POWER slider is in position
OFF/TAPE and the keys of the tape deck are released.
Note: If you run the set on batteries, always be sure to switch the
set off after use. This will avoid unnecessary power
consumption.
03
s
UJ
Adjusting volume and sound
Adjust the volume using the VOLUME control.
Display indication: Volume level from 0 to 32 (AZ1208 only).
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasised if you place the set against
a wall or shelf. Do not cover any vents and leave sufficient room
around the unit for ventilation.
improving radio reception
For
FM
stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For
MW
and
LW
stations, direct the built-in antenna by turning the
whole set. The telescopic antenna is not needed.