Cisco 10700 - Manual (Page 4)

5-4
Cisco 12000/10700 v3.1 Router Manager User Guide
OL-3865-01
Chapter 5 Managing Modules
Module Configuration
Figure 5-1 Configuration Window
Step 2 Choose a Chassis and Module from the list boxes displayed at the left of the window.
Commissioning a Selected Module
Commissioning any card also commissions all the interfaces under the card.
Note You can select multiple Modules (from the Module object selector list) which allows you to
commission all of the selected modules simultaneously. You can choose multiple modules in a
list by holding down the Shift key and then selecting the first and last module in the list. You can
choose multiple individual modules by holding down the Ctrl key and clicking on the individual
modules.
To commission a module, proceed as follows:
Step 1 Open the Configuration window. Refer to the “Viewing the Configuration Window” section on page 5-3
for further details.
Step 2 Choose a Chassis and Module from the list boxes displayed at the left of the window.