Get power, Projector user commands, Format – Canon SX 50 User Manual
Page 160: Response, Description, Example, Commands supported, Environment
Projector User Commands
- 154 -
Revision History / Date
Changes
Revised by
Approved by
GET POWER
Power status inquiry
Format
GET□POWER
?△POWER
Response
g:POWER=<Power status:ID>
<Power status:ID>
OFF Power
Off
OFF2ON
Transitioning from power off→on
ON Power
On
ON2PMM
Transitioning from power on→standby mode
PMM Standby
PMM2ON Transitioning
from
standby→power on
ON2OFF
Transitioning from power on→off
For details on other responses, refer to the "Error List".
Description
This command is used to inquire about the current projector power status.
(1) This inquiry can be made in any status provided that AC power is supplied to the projector.
For the "SX50," the remote mode must be established.
(2) Use the following commands to control the power status with the user commands.
For SX50, SX6, SX60, X600, SX7, X700
Mode
Commands
Local
RC POWER/POWER_OFF
MAIN POWER/POWER_OFF
Remote POWER
ON/OFF
For SX7 Mark II
Mode
Commands
Local
RC POWER/POWER_OFF
MAIN POWER/POWER_OFF
POWER ON/OFF
Remote POWER
ON/OFF
Example
> GET POWER or ?POWER
< g:POWER=ON
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 O
O
O O O
O
O O
O
- - O O x
SX6, SX60,
X600
O
O O
O
O
O
O
O
O
O
O
O
O
O
SX7, X700 O
O
O
O
O
O
O
O
O
O
O
O
O
O
SX7 Mark II O
O
O
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" is returned with the Err response.
Reference