Canon SX 50 - Manual (Page 17)

Projector User Commands
- 11 -
Revision History / Date Changes Revised by Approved by
5. Control Mode
The table below shows the states and limitations of the LOCAL and REMOTE control modes.
Mode
Item
LOCAL mode REMOTE mode
Description
Mode where projector control/operation is
performed by the main unit or remote control.
Initial mode when microcomputer is started.
Mode where projector control/operation is
performed by a PC or other external
device.
(The PC or other external device is
connected by a serial cable.)
Status State indicator Constant remote indicator * 2
LED
ALM ALM state indicator ALM state indicator
Transition method
･ AC power supply to projector
･ Manual power on/off
･ LOCAL command
･ Power management standby/exit mode
transfer
･ REMOTE command
Main unit
keys
All available Only POWER button is available
Remote
control
keys
All available Only POWER button is available
Operation
buttons
Emulation Available * 1 Not available
Switching
5 minutes elapsed from no signal
Operation is as follows depending on the
model.
Model Operation
SX50
･ No switching to
standby or exit
mode.
SX6
SX60
X600
SX7
X700
SX7 Mark II
･ 5 minutes elapsed
from no signal
･ Control is switched to
"local mode" after
mode switching.
Power
management
standby and
exit modes *
3
Return
･ Signal input
･ Remote control button pressed
･ Main unit button pressed ･Emulation
･ REMOTE command