Lamp, Projector user commands, Format – Canon SX 50 User Manual
Page 66: Parameter, Response, Description, Example, Commands supported, Environment
Projector User Commands
- 60 -
Revision History / Date
Changes
Revised by
Approved by
LAMP
Lamp output setting
Format
LAMP=<Lamp output setting parameters:ID>
Parameter
<Lamp output setting parameters:ID>
NORMAL Normal
SILENT Silent
cooling
The parameters which can be set at any given point in time can be obtained using the RANGE
command. For details, refer to the RANGE command.
Response
"i:OK" is returned if the parameter was set properly.
For details on other responses, refer to the "Error List".
Description
This command is used to set the light quantity of the lamp to "NORMAL" or "SILENT" (reduced light quantity
appropriate for silent cooling).
(1) For models other than SX7 Mark II: It can be executed when the projector is in both the remote mode and
power-on status at the same time.
For SX7 Mark II: It can be executed whenever the projector is in the power-on status.
(2) A “busy” response is given while the zoom or focus lens is being driven.
(Refer to the ZCONTDRV command and FCONTDRV command.)
(3) This command is the same as the menu functions in the table below.
Model
Menu
SX50
[Image adjustments] - [Lamp mode setting]
SX6, SX60, X600, SX7, X700,
SX7 Mark II
[Image adjustments] - [Lamp mode setting]
(4) The GET command can be used to retrieve the current lamp output.
For details, refer to the GET command.
Example
Setting
> LAMP=NORMAL
The lamp output is set to “NORMAL”.
< i:OK
Reference
> GET LAMP or ?LAMP
This retrieves the lamp output.
< g:LAMP=SILENT
Acquisition of parameters which can be set
> RANGE LAMP
< r:LAMP=I, NORMAL, SILENT "NORMAL" or "SILENT" can be set for the lamp output.
* Commands are indicated by ">", and responses are indicated by "<".
Commands supported
This defines the environments that support the command (power supply state, input signal state).
SX50
01.00**
SX6
01.01**
SX60
01.01**
X600
01.01**
SX7
01.01**
X700
01.01**
SX7 Mark II
01.02**
O O O O O O O
Environment
This defines the environments that support the command (power supply state, input signal state).
Power
Input
Mode
Model
OFF ON PM
D-RGB A-RGB1 A-RGB2 COMP
Video S-Video D-Video SCART None Remote Local
Remarks
SX50 x
O
x O O
O
O O
O
- - O O x
SX6, SX60,
X600
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7, X700
x
O
x
O
O
O
O
O
O
O
O
O
O
x
SX7 Mark II x
O
x
O
O
O
O
O
O
O
O
O
O
O
* If a state is not supported, "INVALID_MODE" or "NOT_POWER_SUPPLIED" is returned with the Err response.
* When the power supply state is in the process of switching, an "i:BUSY" reply may be sent.
Setting