Galaxy Audio CRICKET POLARITY TEST SET User Manual

Page 5

Advertising
background image

II. Battery Installation for both Send and Receive units
(Use only alkaline batteries)

1. Remove the single phillips head screw from the
battery door on the top of the case.
2. Lift up the door and remove it from the case.
3. Locate the battery terminal snap and attach a 9
volt alkaline battery to it.
4. Slide the battery into the clip mounted to the under
side of the battery door.
5. Reinstall the battery door to the case, making sure
no wires are pinched in the door.
6. Reinstall the single phillips head screw.

3

III. How to set units for testing.

A. Send unit.

1. LO-HI-SPKR: To test speaker polarity put the
selector switch in the "SPKR" position and use
the 1/4" jack marked "EXT SPKR". To test
balanced cable polarity/continuity set the
selector switch to the "LO" position and use
either of the jacks marked "BALANCED OUT". To
test an unbalanced cable for polarity/
continuity set the selector switch to the"HI"
position and use the appropriate "BALANCED OUT"
jack. The "HI" position may also be used for
tests that involve connecting to the input of
an amplifier where the "LO" position is first
proven to be too low a level signal to conduct

Advertising