Galaxy Audio TRAVELER AS-TV10 - Manual (Page 15)

H1. Digital Echo System (AS-TVEC) (see page 10)
1. Turn the Echo Control (H1-1) clockwise to turn on the echo system. Then
use this control to adjust the level of echo in the mix. Echo will be applied to all
3 mic inputs.
2. Adjust the repeat button (H1-2) to select the number of repeats desired.
Adjust the delay button to select the delay time.
3. Mic input jacks (H1-6 and H1-7) are provided for connecting wired Mics. Mic
volume is controlled by H1-4 and H1-5 plus the Master (C-1, Pg.8).
H2. Audio Link Transmitter (AS-TVTX) (see page 10)
This module transmits the entire audio mix from one Traveler to another Traveler
equiped with a wireless Mic/Audio Link Receiver.
1. Turn the power switch (H2-7) clockwise to turn on the transmitter.
2. The LCD display (H2-1) will show “On” and the channel in use when the unit
was last turned off.
3. To select a different channel, press the set button (H2-5) and the channel will
flash in the LCD display. Press the up or down button (H2-6) to select the
transmit channel, and then press the set button again to enter the setting. The
LCD will then automatically display the selected channel. To display the
frequency of the selected channel press and hold either the up or down button.
4. Turn the volume control (H2-7) to adjust the audio transmit level. Use this
control in conjunction with the volume controls on the receiving Traveler.
5. When transmitting signal, the TX indicator (H2-2) will light Green to
show the transmitting condition. The AF Level indicator lights Yellow (H2-3) to
show a low audio level and lights Red (H2-4) to show high audio level.
6. Set up the receiving Traveler according to the procedure outlined in: F.
Wireless Mic/Audio Link Receiver on page 9. Select the same channel chosen
on the transmitting Traveler.