Galaxy Audio TRAVELER AS-TV8 - Manual (Page 2)

AS-TVREC Wireless Mic/Audio Link Receiver
1. This module is the easiest to install since there are no wires to connect (the
connector is a card type on the end of the module circuit board.) This module is to
be installed in only the top left or top right module bays (half width.) Two of
these modules may be installed into a single Traveler.
2. Using a 2mm Hex (Allen) wrench, remove the four screws securing the blank
panel of the module bay to be used. Remove the blank panel and set it aside.
3. Gently slide the AS-TVREC module into the bay (See Photo 2). The module
should slide in freely until about the last ¼” of the installation. At this point a
slight resistance will be encountered as you gently push on the module face to
engage the card’s connector. If you encounter any resistance before reaching this
point do not force it. Simply pull the module back out and start again.
4. Once the module is pushed in all the way, reinstall the four Hex head screws.
Photo 2.
AS-TVCD CD/MP3 Player
1. This module is to be installed only in the second bay down from the top.
2. Remove the four screws securing the blank panel using a Phillips head
screwdriver. Remove the panel and set it aside.
3. Looking inside the bay, locate the wire group and its 5-pin connector for the
TVCD module. This wire group will be found in the wiring harness to the right
side of the bay opening (See Photo 3). Gently pull the wires and connector out of
the bay opening as far as possible.
4. Verify that the wire colors are red, black, and a gray three-conductor cable. (If
there is an orange wire in this group, you have the wrong bundle.)
5. Plug the 5-pin wire connector into the connector in the rear of the TVCD module,
noting that there are alignment tabs that allow only one way of insertion (See
Photo 4). Make sure the plug is inserted all the way in until the tabs lock.