Garelick 19700 COMPACT EEz-In II TRANSOM LADDER - Manual (Page 2)

Instructions for: 19700 SERIES
INVISIBLE LADDER
Write for Garelick Mfg. Co. Phone: 651-459-9795
A complete 644 2
ND
Street, P.O. Box 8 E-mail: [email protected]
EEz-In Catalog St. Paul Park, Minnesota 55071 Website: www.garelick.com
Rev A 08/11
12.627
The location to be used for mounting should be
sufficiently flat and at a 13 degree angle in order to
allow the ladder housing and ladder to function
properly or a mounting shim may need to be fabricated
and placed behind the ladder tube on the transom.
Make sure that the boat will allow for a 3” hole to be
bored into the transom at the desired mounting location
PARALLEL to the waterline and that there is enough
free length [35”] in the boat to receive the ladder tube.
Figure 2: Ladder Details
.
Step 2: Mounting Instructions
Once the location has been determined, drill a 3”
diameter hole in the transom; making sure that it is
parallel to the waterline. Place the ladder assembly
into the hole and mark the four faceplate mounting
hole’s locations. Drill the holes for appropriate 5/16”
diameter hardware [not included]. It is preferred to
through-bolt the assembly for a secure installation [use
lock nuts and backing washers].
Caulk the entire area to be mounted [surfaces and hole
sides] and insert the ladder, secure in place with the
selected mounting hardware.
Secure the far end of the ladder to the boat with a strap
or some other means to keep the ladder tube in place
[not provided as all installations may vary].
Operating Instructions:
Grasp pull ring and pull down to release locking pin while
pulling ladder assembly out until it stops. Then swing ladder
down.
Pull out steps on the left and right and rotate them downward
until they deploy fully.
Reverse process to store.
Secure tube in place with
strap, bracing, or
alternative means to
mitigate swaying.
35”
Bore 3” diameter hole
parallel to waterline.
Ladder must be parallel
to water line.
13 Degree
Transom Area
Pull Ring
Pull Ring Downward
Pull out till
fully
extended
then rotate
down.