Assembly instructions, Frame parts, Step 1- tent set up – Giga Tent FT 027 User Manual
Page 2
ASSEMBLY INSTRUCTIONS
Frame Parts
x10
Fiberglass Poles
Stakes
Step 1- TENT SET UP
To prolong the life of your tent floor we suggest using a ground cloth cut slightly smaller than the floor of your tent and that you select
a clean level area for your campsite.
1) Spread the tent body out on the ground.
2) Fully open all of the poles.
3) Carefully thread the 2 Main Poles through the pole sleeves that cross over the top of the roof of tent (Figure A).
4) Carefully thread the Side Poles through the pole sleeves on sides of tent (Figure B).
5) Starting with the main poles, insert pin on bottom corner into main pole then bend pole and insert pin into opposite pole end.
(Figure C). Repeat for other main pole and side poles.
6) Attach all of the pole clips to all steel poles (Figure D).
7) Tie the top of the tent to the poles (Figure E).
8) Stake the tent down (Figure F).
TENT SET UP DIAGRAM
Main Poles (x2)
Side Poles (x2)
Side Fly Poles (x2)
Center Fly Pole (x1)
C
E
A
B
F
D